Layer-7.png
SHOP NOW

PRODUCTS

MG400 Electromagnetic Gripper kit

MG400 Electromagnetic Gripper kit

MODEL: MG400-EGK

SGD $ 698.00
Contact Us
In Bulk
(per piece)

MG400 Electromagnetic Gripper kit

MG400 Electromagnetic Gripper kit

Specifications

PGS-5 is a miniature electromagnetic gripper, and the number represents the maximum clamping force. It can only control the opening and closing.

 

Performance parameter

Gripping force (per jaw)

3.5-5 N

Opening/closing stroke (both
sides)

4 mm

Opening/Closing time 

0.03s/0.03 s

Weight

0.2 kg

Noise emission

< 50 dB

Ingress protection rating

IP40

Communication protocols

I/O

Nominal voltage

24V DC±10%

Nominal current

0.1 A

Peak current

2.5 A

 

 
 

 

Installation procedure

Step 1: Install the L-shaped gripper to the electromagnetic gripper, and tighten the screw.

Step 2: Install the gripper finger, and tighten the screw, and adjust the installation position of the gripper finger on the L-shaped gripper adapter according to the actual situation. In addition, the protective pads on the left and right sides of the gripper finger can be torn off.

Step 3: Install the gripper mounting plate, and tighten two screws.

Step 4: Install the end flange of MG400 (accessory of MG400) to the gripper mounting plate, and tighten four screws.

Step 5: Install the electromagnetic gripper to MG400 through the end flange of MG400, and tighten the screws on the side of the flange.

Step 6: Connect the cable connector of the electromagnetic gripper to the OUT port of the control box.

Step 7: Connect the gripper cable to the control box.

Step 8: Connect the gripper cable to MG400. Connect 24V and GND port of gripper cable to 24V and GND port of MG400 respectively. Connect H/L port to any DO port of MG400.

 

Shipping list