Layer-7.png
SHOP NOW

PRODUCTS

MQ137 Ammonia NH3 Gas Sensor Module

MQ137 Ammonia NH3 Gas Sensor Module

MODEL: MQ137-MOD

SGD $ 56.00
1
In Bulk
(per piece)

MQ137 Ammonia NH3 Gas Sensor Module

MQ137 Ammonia NH3 Gas Sensor ModuleMQ137 Ammonia NH3 Gas Sensor Module

This MQ137 module is a sensor board designed to detect NH3 Ammonia gas along with other gases. Sensitive material of MQ137 gas sensor is SnO2, which with lower conductivity (high resistance) in clean air. When the target sensitive gas exist, the sensor's conductivity is higher along with the gas concentration rising. The board comes with basic circuitry to change the conductivity or resistance to voltage and output it to header pins, DO and AO.

 

Features:

  • Wide detecting scope
  • Fast response (less than 1s)
  • High sensitivity( 3%)
  • the circuit voltage: DC5V
  • Stable and long life
  • Operating Voltage is +5V
  • Detect/Measure NH3,Ammonia
  • Concentration: 5-500ppm (Ammonia)
  • Heater Resistance(RH): 31Ω±3Ω Room Temp
  • Heater consumption(PH): ≤900mW
  • Sensing Resistance(Rs): 2KΩ-15KΩ(in 50ppm NH3)
  • Sensitivity(S): Rs(in air)/Rs(5000ppm CH4)≥5
  • Slope(α): ≤0.6(R100ppm/R50ppm NH3)
  • Analog output voltage: 0V to 5V
  • Digital output voltage: 0V or 5V (TTL Logic)
  • Preheat duration: 20 s
  • Can be used as a digital or analog sensor
  • The sensitivity of digital output can be adjusted using on board potentiometer
  • The TTL output valid signal is low. (When the output is low, the signal light is on, it can be directly connected to the MCU or relay module)
  • The voltage of the analog output, the higher the concentration, the higher the voltage.
  • Arduino compatible
  • Working humidity: 95%RH (nominal humidity 65%RH)
  • Product dimensions (mm): 35 (L) * 20(W) * 28 (H) 
  • Weight: 14 g

Packing List:

  • 1 x MQ137 Ammonia NH3 Gas Sensor Module

Resources: